High Density 68 Female to 50 pin Female socket. Use this product to convert a narrow 50 pin device to a wide 68 pin. Typically used when the device being converted is not the last device on the cable..
High Density 68 Female to 50 pin male Adapter, mounted on a right angle PC bracket. Use this product to bring an Internal 50 pin SCSI connector to the outside of an enclosure, ending in a high density 68 pin Female connector. Note: requires 50 conductor ribbon cable..
Internal High Density 68 Male to IDC 50 male Adapter, with 10 picofarad capacitors on the "wide" lines. Use this Adapter to plug onto a 68 pin disk drive or onto an Internal 68 pin Female connector on a wide controller, and convert to a 50 pin male. This product will put a load on the wide lines, but does not actively terminate them..
Internal Adapter, High Density 68 Male to 50 pin male on a PC board. Low profile and cost effective, use this Adapter for the following: to convert a wide 68 pin drive to 50 pin narrow, or to convert a wide 68 pin connector on a SCSI controller to 50 pin narrow, where high byte termination is not required..
The SM-065 is an internal adapter, high density 68 male to 50 pin male header, with full Active termination. Use the SM-065 when placing a wide 68 pin drive at the END of a 50 pin ribbon cable..
Internal High Density 68 male to 50 pin male header. Use this Adapter to convert a 68 pin drive to 50 pin. The offset connector design adds just .55"(14mm) behind the drive. See model SM-058 for the version with Active termination on the "wide" lines..